What are some tips to improve the success rate of 3D printing in Jiangsu?
How to achieve better printing results when using Jiangsu 3D printers for printing output? Several practical 3D printing tips can increase your success rate in 3D printing.
The following tips, if you can better master and apply them, will increase the success rate of 3D printing for your 3D printer.
1、Try to design the printing base yourself and avoid using support materials during the design process. Although the algorithms used for support have been improving over time, the removal of support materials will still leave unsightly marks on the model, and the removal process will be very time-consuming. Try to design your model without the help of supporting materials, so that it can be directly 3D printed.
2、Understand the details of your own model, are there any small protrusions or parts that cannot be printed with a desktop 3D printer due to their small size? In your printer, there is an important but often overlooked variable, which is line width. The line width is determined by the diameter of the printer nozzle, and most printers have nozzles with a diameter of 0.4mm or 0.5mm. In fact, the circles drawn by 3D printers are twice the size of the line width.
3、Remember the 45 degree rule, any protrusions exceeding 45 degrees require additional support materials or sophisticated modeling techniques to complete model printing. Design your own support or connecting objects (cones or other support materials) and incorporate them into your model.
4、Adjust the printing direction for appropriate accuracy, always use the feasible resolution direction as the printing direction for your model. If necessary, the model can be cut into several blocks for printing and then reassembled.
5、Adjust the printing direction according to the source of pressure, and when force is applied to the model, we must ensure that the model is not damaged. To ensure that your printing direction reduces stress concentration in certain areas, we can adjust the printing direction so that the printing line is perpendicular to the stress application point. The same principle can also be applied to ABS resin commonly used for printing large models. During the printing process, these large models may crack along the Z-axis due to cooling on the printing table.
Through the above tips, if you master them proficiently during printing, the success rate of 3D printing in Jiangsu will be higher!
32048202001166
